Made of heat-treated 316L stainless steel with a small thermal expansion coefficient

440C stainless steel ball and sapphire shim, wear-resistant with a small friction coefficient

Suitable for Ø76.2 mm optical components

Made of heat-treated 316L stainless steel with low thermal expansion coefficient

440C stainless steel ball and sapphire gasket, wear-resistant with low friction coefficient

Suitable for Ø30 mm optical components

Applicable for MT series optic mounts with optic diameters of Ø25.4 mm or Ø50.8 mm, or for optic mounts with a rear plate thickness of 15 mm

Sturdy 45° mounting

Top M4 tapped hole for mounting the optic mount, includes two Ø2 mm alignment pin holes for precise installation

Three-point boss design, low deformation

Snap ring + wave washer to secure optical components, low deformation

Specially treated 316L stainless steel material, superior stability

100 µrad repeatability

Avoid or return to the optical path

Stainless steel material ensures long-term stability

Made of heat-treated 316L stainless steel with low thermal expansion

440C stainless steel balls and sapphire seats, wear-resistant with low friction coefficient

Including three M4 countersunk holes for multiple mounting options

Made of heat-treated 316L stainless steel with low thermal expansion coefficient

Multiple optical component mounting methods

440C stainless steel balls and sapphire seats, wear-resistant with low friction coefficient

Made of heat-treated 316L stainless steel with low thermal expansion coefficient

Mounting cube beamsplitters to setscrew-type mounts

Four-sided light transmission with large clear aperture

316L stainless steel for high stability

Complete variety with multiple optional styles

Compatible with MT series optical mounts

Stress-relieved, heat-treated stainless steel material with high stability;

M4 screw thread on the top, M6 screw thread on the bottom;

Various length available;

Made of heat-treated 316L stainless steel with low thermal expansion coefficient

Flexure spring and set screws securing optical components

Suitable for mounting optical components with Ø12.7 mm or Ø25.4 mm diameters

Heat-treated, stress-relieved stainless steel material provides greater holding force and high stability;

Reversible symmetrical design supports left and right-hand installation;

3-point contact with flexible clamping;

316L stainless steel material after heat treatment, with a small coefficient of thermal expansion

440C stainless steel balls and sapphire seats, wear-resistant with a small friction coefficient

Multiple optical component fixation methods

Made of heat-treated 316L stainless steel with low thermal expansion coefficient

Multiple optical component mounting methods

440C stainless steel balls and sapphire seats, wear-resistant with low friction coefficient