The LBTEK 2D Adjustable Prism Mount is suitable for installing prisms, cubes, and other optical components. It comes with an adjustable clamping arm CA-1 (available for separate purchase), with a mounting platform size of 45 mm × 26 mm, capable of holding optical components with a maximum height of 26.2 mm. The mount base is equipped with two M4 countersunk holes for connecting to optical posts. Two M6x0.25 adjustment screws allow the mount to achieve ±4° pitch and yaw angles. The ends of the adjustment screws feature hex sockets, which can be adjusted using a 2 mm hex wrench.

LBTEK Height-Adjustable Clamping Arm is used to press cubic optical components onto the platform, featuring an M4 mounting stud at the bottom. The clamping height options are 24.7 mm, 40 mm, and 60 mm.

The LBTEK Clamping Arm Height Extension Post can be threaded onto the clamping arm to increase the height. It comes in three models: CA-1E, CA-2E, and CA-3E, with lengths of 31.5 mm, 50 mm, and 71 mm respectively.

LBTEK 2D Adjustable Prism Mount is suitable for mounting prisms, cubes, and other optical components. It comes with an adjustable clamping arm CA-3 (available for separate purchase). The mounting platform measures 54.5 mm × 70 mm, and can hold optical components with a maximum length and width of 51 mm and a maximum height of 60 mm.

The LBTEK Adjustable Pitch and Rotation Mount PRM provides pitch and rotation adjustment for optical components or optomechanical assemblies. This mount consists of a top plate and a base, which are magnetically coupled. The top plate of the mount allows for 360° rotation adjustment and ±3° pitch adjustment. The rotation can be locked using the 2.0 mm hex fixing screw on the side of the mount, while the ±3° pitch adjustment is controlled by the hand-turned knob on the top plate. The top plate features four M4 threaded holes for compatibility with the CA-X series clamping arms. The surface of the top plate is engraved with alignment lines, including both 25 mm and 12.5 mm square patterns. Both the top plate and base can be mounted onto an optical table or post using M6 countersunk holes and M4 countersunk holes, respectively. If needed, the PRM mount can be used upside down. However, please note that if the top plate is used as the fixed part of the mount, the pitch adjuster cannot be rotated.